top of page

What Are the Signs That Your Bearings Might Be Failing?

When the bearing of a machine fails, it can be frustrating as it causes an interruption in daily operations. Especially if the machine is involved in bigger productions, then the slowdowns and shutdowns can be difficult and affect the production process. Thus the bearings of the machine must be in good working condition to keep the production intact. You can easily identify the problems in your bearings early if you keep an eye out for them. The majority bearing distributors in India suggest that entrepreneurs always look out for the signs and identify the same sign.

What are the factors that cause bearings to fail?

A few common factors that cause the bearing of the machine to fail are as follows:

Rust and corrosion:

One of the easiest signs that will come to your notice is when you see rust and corrosion appearing on your bearings. If the machine has been contaminated with moisture or water for a long time, the bearing might get damaged due to rust and corrosion.

Improper installation:

If the bearing has been installed properly then, then the machine will exhibit problems in the long run. If you find the machine malfunctioning or exhibiting any problem it is better that you check the installation of the bearing to prevent it from getting damaged permanently.

Mishandled bearings:

If the machine operators are not knowledgeable about handling the bearings, then the machine handling process malfunction will permanently damage the bearings. Hence, an experienced person must always handle a machine in a factory.

Insufficient lubrication:

When a machine operates, friction is caused due to the operation. If the lubrication is not sufficiently present in the machine, the bearing will eventually get damaged. Hence keep checking the lubrication of the machine and you can avoid all types of damages in the bearing of the machine.

Electrical plating:

Electrical plating can affect the condition of the bearings. However, it depends on the material used to make the electrical plating on the bearing.

Huge load:

If the bearing cannot bear the load imposed on the machine, the same will fail in the long run. Hence it is always essential to check the amount of load the machine and the bearings can handle before imposing the same.

Approach Bearing House for wholesale and retail shop for A to Z bearings. To know more, check our website. Contact us for all types of bearing needs.

10 views0 comments
bottom of page